Installation and commissioning of anti-slip chains

Anti-skid chains Anti-skid chains due to freezing weather, snow on the road, many cars are equipped with anti-skid chains to avoid accidents. The principle of anti-skid chain is to concentrate the gravity of the vehicle to several points of the chain, generating a huge pressure, rolling through the ice and snow layer straight to the road, thus locking the chain to increase the friction and increase the safety factor of the vehicle driving. The editor found some small knowledge about anti-skid chains, hoping that the public travel safely. Installation of anti-skid chains This is a skill course that people may never chains use in their lives. But as you who live in cold climates, it is very useful. It may sound daunting to people, but actually installing and removing chains is a very quick process, even when done in bitterly cold weather. With 15-30 minutes of expert guidance, you'll be driving safely and reliably through the winter in no time. It is if you can install and remove the chain in your driveway or some relatively safe place. Of course, when you have to install or remove them on the road, make sure you do it on a safe and level roadside. Wherever possible, be sure to leave yourself at least 10 feet of open space in front of and behind your vehicle, allowing you plenty of room to move the chain. Also make sure you have activated your parking brake before your hand touches anywhere near the tire to avoid an accident. It is a good idea to support the tires with wooden blocks as an additional protection. Last, but not least, clean off any excess snow from your tires. First of all, make sure that your car is driven by the front or rear wheels, because the chains must be hooked to the set of tires that play a major role. Once you know which set of tires you need to apply the chains on, clear as much snow as possible from around the tires to create a flat surface. Spread the chain under the car and place the first gear of each chain attached to the ground against the tire. Make sure the grainy side of the chain is facing the ground, this is the part of the chain that gives the traction. If you have a rear-wheel drive car, you will have to bite the chain backwards. If it's a front wheel, you'll want to push it forward. Check to make sure that each tire is holding the chain and that each side is lapped with a strand of gear. Then get in the car, start the engine, and slowly and carefully take the chains and push the car forward or backward about 2 feet. Once your tires are positioned at right angles to the chain, pull off the ports that lap over the top of the tires. Each end must be a perfect fit for the entire chain gear. Give yourself 1 to 2 inches of clearance first, then bolt the unit tight through the two opposite sides of the chain link. Each rubber ring of the chain has 4 metal hooks evenly spaced around it. Each metal hook is secured in a criss-cross pattern on the hubcap side of the tire. This ensures that your chain will not slip off. The chains should now be securely fitted and ready to give you traction on snowy roads. However, don't assume your chains will keep you flying through the rough driving conditions. Start slowly and pay attention to the sounds your car makes, that may be a warning that your chains are loose or that your tires are not mounted properly (question the chain issue). No matter how safe they are to use, it's not wise to drive a tire with chains on it at 40 mph. Bad weather doesn't last forever, so when it stops snowing, it's time to remove the chains from your car. Do not, under any circumstances, drive with chains on non-snowy roads, as this can seriously damage your tires. Removing chains is much easier than installing them. Just do the opposite, remove the chains and store them in a dry place for the next winter. Chains, chains